Physiotherapy
Volume 96, Issue 2 , Pages 120-129, June 2010

Cervical spine mobilisation forces applied by physiotherapy students

  • Suzanne J. Snodgrass

      Affiliations

    • Discipline of Physiotherapy, University of Newcastle, Hunter Building, Callaghan, NSW 2308, Australia
    • Corresponding Author InformationCorresponding author. Tel.: +61 2 49212089; fax: +61 2 49217902.
  • ,
  • Darren A. Rivett

      Affiliations

    • School of Health Sciences, University of Newcastle, Callaghan, Australia
  • ,
  • Val J. Robertson

      Affiliations

    • School of Health Sciences, University of Newcastle, Callaghan, Australia
  • ,
  • Elizabeth Stojanovski

      Affiliations

    • School of Mathematics and Physical Sciences, University of Newcastle, Callaghan, Australia

published online 23 December 2009.

Abstract 

Objectives

Postero-anterior (PA) mobilisation is commonly used in cervical spine treatment and included in physiotherapy curricula. The manual forces that students apply while learning cervical mobilisation are not known. Quantifying these forces informs the development of strategies for learning to apply cervical mobilisation effectively and safely. This study describes the mechanical properties of cervical PA mobilisation techniques applied by students, and investigates factors associated with force application.

Participants

Physiotherapy students (n=120) mobilised one of 32 asymptomatic subjects.

Methods

Students applied Grades I to IV central and unilateral PA mobilisation to C2 and C7 of one asymptomatic subject. Manual forces were measured in three directions using an instrumented treatment table. Spinal stiffness of mobilised subjects was measured at C2 and C7 using a device that applied a standard oscillating force while measuring this force and its concurrent displacement. Analysis of variance was used to determine differences between techniques and grades, intraclass correlation coefficients (ICC) were used to calculate the inter- and intrastudent repeatability of forces, and linear regression was used to determine the associations between applied forces and characteristics of students and mobilised subjects.

Results

Mobilisation forces increased from Grades I to IV (highest mean peak force, Grade IV C7 central PA technique: 63.7N). Interstudent reliability was poor [ICC(2,1)=0.23, 95% confidence interval (CI) 0.14 to 0.43], but intrastudent repeatability of forces was somewhat better (0.83, 95% CI 0.81 to 0.86). Higher applied force was associated with greater C7 stiffness, increased frequency of thumb pain, male gender of the student or mobilised subject, and a student being earlier in their learning process. Lower forces were associated with greater C2 stiffness.

Conclusion

This study describes the cervical mobilisation forces applied by students, and the characteristics of the student and mobilised subject associated with these forces. These results form a basis for the development of strategies to provide objective feedback to students learning to apply cervical mobilisation.

Keywords: Cervical vertebrae, Physiotherapy techniques, Musculoskeletal manipulations, Students

To access this article, please choose from the options below

Login to an existing account or Register a new account.

  • Purchase this article for 31.50 USD (You must login/register to purchase this article)

    Online access for 24 hours. The PDF version can be downloaded as your permanent record.

  • Subscribe to this title

    Get unlimited online access to this article and all other articles in this title 24/7 for one year.

  • Claim access now

    For current subscribers with Society Membership or Account Number.

  • Visit SciVerse ScienceDirect to see if you have access via your institution.
 

PII: S0031-9406(09)00100-X

doi:10.1016/j.physio.2009.08.008

Physiotherapy
Volume 96, Issue 2 , Pages 120-129, June 2010